-
Rollback the "u-blox Universal GNSS" sensor to the default "USB Serial Device"
Rollback the "u-blox Universal GNSS" sensor to the default "USB Serial Device"Once you configure your ublox GNSS receiver to work as a "Windows Location Sensor" device, t
2022-03-02 mei 566
-
Use the U-center test evaluation tool to set the common setting operation steps of the TOPGNSS receiver module
U-center tool commonly used setting operation steps (this operation is applicable to all TOPGNSS GNSS receivers with 8030 chip design module)(1) Change the baud rate(2) Change the refresh rate(3) Set
2021-09-15 mei 1413