-
Rollback the "u-blox Universal GNSS" sensor to the default "USB Serial Device"
Rollback the "u-blox Universal GNSS" sensor to the default "USB Serial Device"Once you configure your ublox GNSS receiver to work as a "Windows Location Sensor" device, t
2022-03-02 mei 762
-
Use the GNSS Viewer_V1.2 tool to test and set up the GN-02B GNSS module
GNSS Viewer_V1.2 tool Downloadhttps://www.topgnss.com/upload/file/GNSS_Viewer_V1_GNSS_Viewer_V1_2_0_0.zip Note: This tool is only suitable for parameter setting and saving of GN-02B module.Use the GNS
2021-09-23 mei 1284
-
Use the U-center test evaluation tool to set the common setting operation steps of the TOPGNSS receiver module
U-center tool commonly used setting operation steps (this operation is applicable to all TOPGNSS GNSS receivers with 8030 chip design module)(1) Change the baud rate(2) Change the refresh rate(3) Set
2021-09-15 mei 1623